How to time my co2?

[Rasmusm]

Hey

Im trying to understand this new ghl computer I have the profilux plus II.
I figuret out last night how to activate the s1 socket in my power bar, and plug in my magnet valve for my co2 it runs between pH6.95 - 7.00 thats all fine, but it does it 24/7. I use to cut off the co2 duing the nights and then start it earlie in the morning. Is it possible to put a timer on that s1 in the power bar? If yes how can I do it?

Thanks for reading my newbie question :-)
Merry cristmas

Kind regards Rasmus
Denmark

[Wirus]

There are two possibilities:
- there is a night time option in the Profilux Control menue to set a different/higher value for a spevific time period (preferred)
- program a timer for daily "ON" and use an automatic logic gate to code it as PH1 AND Timer1. You have to assign the magnetic valve to that logic gate then

[Rasmusm]

Thank you, I will check up on it.
Actualy its not bad having the co2 running all the time it seems.

[Blahenazo]

Why not do it like this ?
- don't dose kalkreactor water @ night , since you don't feed new water into the reactor the ph should be 'stable'

[Rasmusm]

It is a fresh water tank :-)

[Blahenazo]

then you need to use the logic Wirus said

[Rasmusm]

Okay I will try that, thanks alot

[Rasmusm]

Ok i figured out how to time my Hydor koralia evolution 2800l/h
Now its plugged into s2 on powerbar and sat on a timer from 10:00 - 22:00 which is perfect.
But how do i activate the feeding pause ? When i press esc on computer I get 300sec feeding pause. I would like that to work :-)

[GHL Support]

What do you want whith the feeding pause?

Do you want to disable the CO2 during a feeding pause? This could made via programmable logic.

[Rasmusm]

What do you want whith the feeding pause?

Do you want to disable the CO2 during a feeding pause? This could made via programmable logic.

I want to stop the powerhead duing feeding pause, if thats possible.