so, I did many tests here and I can't see that there is an issue or a bug
I did this:
pump 1 has min 1% and max 100%
1-10V-interface 1 (ProfiLux) and interface 5 (expansion box) have voltages 3V and 8V, "pump 1"
then I measured the voltage on both 1-10V-outputs (both had the same readings)
no feed pause: alternating between 3V and 8V
in feed pause: 0V (when "off") resp. 3V (when "at minimum")
-> the output voltage was 100% correct in any case
I am not sure if the Tunze pump is supposed to switch off completely at a 0V control signal
can you supply the Tunze over a switchable socket in order to switch the power completely off (then use function "pump x" and set the check mark "pump completely off during feed pause" in the pump settings)?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks