-
Control 1-10v output based on KH director Alk level
Hi I have a Deltec CR Twin Tech calcium reactor I would like to have a 1-10v output based on my KH director reading
For example
If KH director is reading higher then 8 DKH then output 10v so it will turn off the feed pump on the calcium reactor
If kh director is below 8 DKh output 0v so feed pump is on
Is this possible?
Last edited by Gael; 02.08.2023 at 08:43.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks