Analog Sensors.

[Luisagos]

I just upgraded to P3 and I can not find the 2 analog Sensors inputs in the program, so I can use them.

I see the 4 digital sensors screen, but not the analogs.


Thank you.

[Matthias]

the PLM-ADIN works in P3 and expansion box correctly

in order to help you: could you give us some more and detailled information, please?

[Luisagos]

I have the PLM-ADIN card plug in, and I don't see where I can program it.

What screen is the PLM-ADIN I/O located at?

I don't see any functions reference to it.

[Matthias]

under "sensors" are entries for "voltage 1 + 2"

[Luisagos]

Thank you,

Whats the problem if i dont see "voltage 1 + 2" on the screen ?

[Matthias]

is the card detected after booting? "PLM-ADIN" should be displayed there.

[Luisagos]

It was not showing up when I boot it up.

I turn the power off and remove the adin card, rebooted the system. Turn power off again.
Put the adin card back in, and now it see it.

But this created a new problem, my lan card is not being seen now, only sees the serial on slot 0, and adin is on slot 1.
USB works, but the LAN does not.

I also notice, I am getting examine hardware on bootup.

Removing the adin card does not bring the lan card back.



Using ProfiLuxControl 5.0.0.7 , with firmware ProfiLux3_V500i.mhx

[Luisagos]

OK, I got LAN working by resetting my router.

Now, what does it mean examine hardware on bootup ?

Should I be worried about this?

Thank you.

[Matthias]

examine hardware means that ProfiLux performs a self check and scans all slots if there are cards present

we found out in the last days that under certain circumstances not all cards are detected after every reboot

in firmware 5.00k this has been fixed (comes soon)

[Luisagos]

Thank you Mattias.