-
Temperature probe failure??
I suddenly have an alarm on my temperature and on the P4 and Touch it shows Temp ***
Does this mean the probe has failed? If so, I assume as it is under a year old it is under warranty. Is there anything I can try to test it?
Meanwhile, as my heaters are heater stats, I will set them to always on and let the heater stats take control of themselves until this is sorted.
Oh, and I have made no changes for weeks to the software and noe of the kit has been disturbed.
-
-
Originally Posted by
itsmorefun
Hi,
Thanks but I'm afraid this is not the same problem. The probe has been in place for months and workng perfectly. I have powered down and restarted and it comes up again as ***. I checked the back of the P4 and everything seems tight. I have made no changes, it just suddenly went during the England match!
To make matters worse, I was moving my calibrated thermometer to the DT to keep a closer eye on it... and I dropped it on the floor :-(
I am currently relying on the inbuilt stats on my heaters to maintain a roughly OK temperature.
So I am still wondering, is this probe dead???
-
I have looked at the store and I am unclear. Which temp probe is the correct one for a P4 please?
-
Hi there,
Please open a support ticket and attach a copy of your sales receipt so we can troubleshoot this further.
P4 temperature probes use a BNC connector. The digital temperature probe is the direct replacement to your current probe.
-
Hi Vinny, I have done some digging... and I have had the kit for over a year - so I guess it won't be under warranty anyway. I will open a ticket as suggested. Thanks for the info about the replacement type.
Cheers
John
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks