Hi!
I want my heater to turn of if the levelsensor activates. I tried NAND but that dont work. How should i do it?
Hi!
I want my heater to turn of if the levelsensor activates. I tried NAND but that dont work. How should i do it?
Use the XOR function.
Setup the PL gate
Input 1
Temperature probe 1
Input 2
Fill Water (Select the control circuit that has your level sensor function assigned)
Assign the PL gate
Select the socket that has the heater connected and set the function to PROGRAMMABLE LOGIC. Select the gate number you used when you created the PL function.
Thx😁. The xor function isint in the pdf with the instructions. Time to update 😉
Skickat från min G8141 via Tapatalk
Is it the Un equal function? If it is dosent that meen that if the heater is off and the full water turns on, the heater will turn on?
Skickat från min G8141 via Tapatalk
Bookmarks