you don't need to do the initial steps every time, this makes no sense
you do this once and the the KHD is good to work
1 or 2 measurements after initial setup may differ from the real value, needs time to adjust
-> so your first measurment was a bit too low, the 8.3 masurements seem to be more correct
-> if you want to see the same value as test kit shows you can manipulate the shown value
but don't do the initial steps again and again ...
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks