I have 2 doser 2.1's I updated since GCC said the firmware was out of date. So I did and they do not show any stirrers, dosing pumps, kh Director..........
I spend way to much time trying to make this stuff work.
I have 2 doser 2.1's I updated since GCC said the firmware was out of date. So I did and they do not show any stirrers, dosing pumps, kh Director..........
I spend way to much time trying to make this stuff work.
Screenshot (20).jpg
This is after I click on Dosing pumps. There are none.
And before everyone asks, I did save my configuration and then reloaded it after the update.
This is likely an issue with the PAB-System.
Try resetting PAB in GHL Control Center and re-assign the GHL-Devices again.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Ok I guess I will search how to do that even though the one doser 2.1 is completely stand alone and has no PAB devices connected to it.
Bookmarks