Results 1 to 4 of 4

Thread: Powerbar2Dim

  1. #1
    Join Date
    08.02.2011
    Posts
    12

    Default Powerbar2Dim

    Hello,

    I have a Powerbar2Dim-F/B, how connect it on profilux 3 ?
    I try to connect it to S1-S4 port on Profilux (i don't use S1-S4 and S5-S8) and configure the page "switch channels and outlets":
    Capture1.PNG
    I assigned the number 19 to the first outlets (i have 3 powerbar6D from 1 to 18):
    Capture2.PNG
    And no working

    How to connect this Powerbar2Dim-F/B ?
    I want to connect my heaters to this powerbar, is it a good idea ?
    Is it the same powerbar but with 2 outlets ?
    Capture3.PNG

    Best regards

  2. #2
    Join Date
    18.02.2009
    Location
    Kaiserslautern
    Posts
    7,710

    Default

    the dimmable powerbar must be connected to an 1-10V intervace (e.g. L1L2), not to a S-port

    I hope this wrong connection did not destroy the dimmable powerbar and/or ProfiLux interface
    No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
    Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.

  3. #3
    Join Date
    08.02.2011
    Posts
    12

    Default

    Thank for your reply, i connected it to L1L2 now and the S1 led is red, what should I still set ?
    The profilux is running fine apparently.
    What is the clusters near the led on this powerbar ?

  4. #4
    Join Date
    08.02.2011
    Posts
    12

    Default

    Is there a manual or information on this powerbar ?
    I can not find anything even on the official website...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •