Results 1 to 3 of 3

Thread: Vortech Pump channel question

  1. #1
    Join Date
    23.05.2010
    Location
    aalborg
    Posts
    173

    Default Vortech Pump channel question

    One fast question, i cant seem to find anything in the manual about this.

    Pump channel, if i want 2 pumps to run in sync, so the 2 vortech pumps always do the same mode/speed should both be set to channel 1 then?

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    That depends on how you have the pumps setup.

    If you are using the Vortech controller options, you would select a pump and set the mode to Synchronous slave.

    If you are assigning a Vortech as a Stream pump, you would first select the pump number to assign, then go to a Stream Group and assign multiple pumps to the same group. This group would then be set to run on PERMANENT mode.

  3. #3
    Join Date
    23.05.2010
    Location
    aalborg
    Posts
    173

    Default

    Thanks, so this would be a correct setting? I am using the Vortech Controller options to run it.
    v1.JPG
    v2.JPG
    v3.JPG

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •