Hi
After struggling to connect my new Doser 2.1 to GCC i finally get it to work trough wireless but everytime I start GCC on my computer the error code 28 flashes after a minute and the program shuts down?
Hi
After struggling to connect my new Doser 2.1 to GCC i finally get it to work trough wireless but everytime I start GCC on my computer the error code 28 flashes after a minute and the program shuts down?
Anybody that can assist?
This is usually due to a weak WiFi signal, or interference on the channel your WiFi is currently running.
What firmware version is the Doser currently on? Make sure to upgrade to latest version if not on latest.
You could try to change the WiFi channel on your WiFi router/AccessPoint.
Info on WiFi: https://www.metageek.com/training/re...ls-1-6-11.html
marco
RS Reefer 450; /////GHL P3 * 2x PB5.1 * PLM-PWC * -> * 2x Mitras LX 7206, Doser 2 SA Royal Exclusiv RD3 80w(10v) * Bubble King Double Cone 180 w/ RD3
GHL Owners Facebook Group: GHL Owners / ProfiLux / Mitras / etc
Hi and thanks for the help
The dosers firmware are the latest version but I will try to change the wifi channel. I have a network/lan cable at home that i could route from the tank to my computer if wifi doesnt work, or is usb a better choice?
LAN is always better than WiFi, less chance for interference. If that’s an option, I’d go that route
marco
RS Reefer 450; /////GHL P3 * 2x PB5.1 * PLM-PWC * -> * 2x Mitras LX 7206, Doser 2 SA Royal Exclusiv RD3 80w(10v) * Bubble King Double Cone 180 w/ RD3
GHL Owners Facebook Group: GHL Owners / ProfiLux / Mitras / etc
Bookmarks