I am having trouble getting the doser to work.
Finally got it connected to wifi, but every time I try and calibrate the doser, I will get the "communication error code 50"
Does anyone have the fix for this?
I am having trouble getting the doser to work.
Finally got it connected to wifi, but every time I try and calibrate the doser, I will get the "communication error code 50"
Does anyone have the fix for this?
Hi
Have you tried the settings via USB and the GHLControlCenter?
Which firmware is on the doser and which version of the ControlCenters do you use?
regards Pit
Yes, I originally connected through USB to set up wifi. (my aquarium is not close by my computer)
After the wifi connection was setup, I moved the doser to the aquarium to try and set it up.
firmwareversion 1.24
GHL control center is version 1100
Do you have a sufficient WLan signal on the Profilux?
Can you post a screenshot of the WLan settings here
regard Pit
Yes, there is sufficient signal. I can get it to work sometimes, but 95% of the time I get the error code.
Here is a screen shot of my wifi settings. Thank you
wifi.jpg
Last edited by travis_ham; 02.12.2017 at 19:46.
Please try with GCC 1103.
Just downloaded 1103, still the same code appears.
Bump! anyone?
We will look into this further.
On the meantime, we ask that you calibrate the Doser via GCC (USB), myGHL, or GHL Control app.
is this only with WiFi, only with USB, or both?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks