Tagging along here as I have the exact same issue.
Also to note I have tested this with Flow Sensors aswell, the P4 only see's 1 sensor when connect the Y-Cable.
Tagging along here as I have the exact same issue.
Also to note I have tested this with Flow Sensors aswell, the P4 only see's 1 sensor when connect the Y-Cable.
Are you selecting the correct sensor number to assign to each Control Circuit?
Please post a screenshot of your LEVEL settings.
Hi
allow us a few days to have a deeper look into this.
Will come back to this topic ASAP.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Here it is with the Flow Sensors plugged directly to Port 1 & 3
FlowSensor1and3.JPG
Here it is with the Flow Sensors plugged into a Y Cable on Port 3[Green]
FlowSensorYon3.JPG
Here it is with the Flow Sensors plugged into a Y Cable on Port 1[Purple]
FlowSensorYon1.JPG
I also have the same results as the OP with the float switches.
Thanks for posting about you having the same problem JunkieHobbo. Hopefully we can get this sorted out soon!
Vinny / Matthias - attached are three images of my Level Settings, as requested. They are:
- 2 float sensors, triggered, connected directly to Purple and Green Ports (both sensors are recognised by the P4 correctly)
- the same 2 float sensors connected via PL-LY splitter to Purple Port (only 1 sensor being recognised, as sensor 1)
- the same 2 float sensors connected via PL-LY splitter to Gren Port (only 1 sensor being recognised, as sensor 3)
As previously mentioned, I get the same error no matter whether I use float sensors, optical sensors or the leak detect module.
Hi Vinny / Matthias. Have you been able to replicate the problem we are experiencing with the P4 level sensors? Do you have any idea how soon it can be fixed?
Thanks very much.
Hello Stephen,
could you please tell me the version of gcc and the firmware you use on profilux 4.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks