-
Profilux 3 ex and power bar 6D
Every time I disconnect my Profilux power supply - my power bar switches itself off.
Is there a way to keep the power supply to the things attached to powerbar running.
Eg: My return pump and mitras are connected to power bar --> and they switch off when I disconnect the profilux.
-
You can configure the initial states for your powerbar. This will tell the Powerbar how to react when it is no longer communicating with your ProfiLux.
Powerbar 6D (NON-PAB)
1. Leave only the Powerbar 6D connected directly to the ProfiLux, all other devices connected to the S-port must be disconnected for this to work.
2. Go to the SWITCH CHANNELS AND OUTLETS settings page and select the option PROGRAM DIGITAL POWERBAR...
3. Select INITIAL STATE OF A DIGITAL POWERBAR.
4. Check the boxes for the sockets you want to stay on, in case of a disconnect from the ProfiLux.
5. Click Next, then click PROGRAM NOW.
6. Reconnect all other devices originally connected to the S-port(s).
Powerbar 6D-PAB
1. Go to the System settings page and select the Powerbar 6D-PAB from the list of PAB-devices
2. Click on CONFIGURATION
3. Check the boxes for the sockets you want to stay on, in case of a disconnect from the ProfiLux.
4. Click OK.
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks