-
Help assigning slave to doser2.1
I feel I must be missing something silly.
I have just started setting up my slave doser to my doser 2.1, I have been following the online video for assigning a PAB unit and all seemed to be going well, I have got to a point where the slave has been assigned and shows up in the system settings, the Tab shows the slave as a PAB-Device running version 1.24 and a PAB address of 18, my issue is when I go to configure this pump I get a message saying the PAB device is not responding.
Currently the slave mimics exactly what pump 1-4 doses.
It so happens that I am setting up two identical units and they are both at the same state.
Hope you can point me in the right direction.
Thanks Vince
-
Hi there,
Please download and use this version of GCC, then let me know if you were able to successfully assign the slave doser:
https://www.aquariumcomputer.com/dow...nter-v1-0-9-1/
-
Hi Vinny,
I have downloaded the new GCC, unfortunately I am now no longer able to connect to the doser 2.1, I have tried creating a new connection within settings, but this will not connect either.
-
Just another note, the doser 2.1 is flashing red.
-
Any Idea Vinny ?
These dosers are supposed to be heading off to an installation at 'The Deep in Hull' one of the largest public aquariums in Europe, seems like I am going to show up with dosers that don't work.
I would rather that was not the case.
Thanks
-
Another thought that may help.
Would it have caused a problem having copied a dosing profile over from a doser 2 ??
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks