Results 1 to 6 of 6

Thread: Program incomming analog alarm from 3 party equipment ...

  1. #1
    Join Date
    14.10.2009
    Location
    Dubai
    Posts
    168

    Default Program incomming analog alarm from 3 party equipment ...

    Hello ghl users, im need some advise on conbecting the following.

    I have a AMS DaStaCo calcium reactor which has a alarm out connection on its Integra controller. This alarm cable goos from the calcium control unit to a breaker box which is connected to a PLM-ADIN connected to PL3eX.

    Now i want to know how i can setup (assign) to have the PL3 receive, display and forward all incoming alarm signals from the reactor and for example switch it off via ghl powerbar...

    Appreciate all input ..

    Jan
    Last edited by diverdutch; 01.08.2017 at 20:19.

  2. #2
    Join Date
    27.05.2015
    Posts
    2,486

    Default

    Hi Jan,

    You can set the on/off behavior by finding out which INPUT on the ADIN card you have the breakout box connected to and assigning that INPUT to the desired socket.

    For example, if you have it connected to the ADIN card on INPUT 1, you would go to the SWITCH CHANNELS AND OUTLETS settings page and select the desired socket. This socket should then be given the function, DIGITAL INPUT 1.

  3. #3
    Join Date
    14.10.2009
    Location
    Dubai
    Posts
    168

    Default

    Txs vinny!

    How about the incoming alarm signal itself ? How and where do i register it in PL3 that its the calcium reactor..
    Last edited by diverdutch; 07.08.2017 at 03:18.

  4. #4
    Join Date
    27.05.2015
    Posts
    2,486

    Default

    At this time an alarm cannot be triggered by a Digital input command.

  5. #5
    Join Date
    14.10.2009
    Location
    Dubai
    Posts
    168

    Default

    Quote Originally Posted by Vinny View Post
    At this time an alarm cannot be triggered by a Digital input command.
    so how can I have the profilux give an alarm from incoming signal via the adin card?
    ?

  6. #6
    Join Date
    06.11.2014
    Posts
    7

    Default

    I have the same problem too as with the alarm cable connecting to the Adin card can i connect it so that it tells me that the Dastaco has switched itself off and the alarm has gone off?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •