Two optic sensors ATO

[KZGHLREEFER]

I just followed the GHL's video in YouTube, it's seems set, but nothing happend with my Doser 2.1 slave.

Please see the screen shot=CONFIG]9500[/ATTACH]???? 2017-07-27 ??5.43.02.png???? 2017-07-27 ??5.43.51.jpg

I tried the doser setting from GCC, it's working. Have no idea what is getting wrong.

[Vinny]

Try switching the Sensor 1 and Sensor 2 numbers:
- Sensor 1 should be 3
- Sensor 2 should be 4

Also check to see that your PL-LY splitter is connected to the LEVEL 3/4 port on your ProfiLux. This is the GREEN port.

[KZGHLREEFER]

Try switching the Sensor 1 and Sensor 2 numbers:
- Sensor 1 should be 3
- Sensor 2 should be 4

Also check to see that your PL-LY splitter is connected to the LEVEL 3/4 port on your ProfiLux. This is the GREEN port.

Hi, thanks for the reply. According to the 3/4 sensors, I'm sure the 4 is on the top and 3 is in lower level. Does this matter?

[Vinny]

The Purple port is Level 1/2 and Green port is Level 3/4.

If you've assigned sensor 1 to be on Level 3 and sensor 2 to be on Level 4, then it must be connected to the Green port via a PL-LY splitter cable. You can determine which is Level 3 and Level 4 on the splitter cable by dipping each sensor in water to see which sensor reacts to the water. The sensor status can be seen in the LEVEL settings page; see STATES.