Results 1 to 4 of 4

Thread: Mitras LX7 GHL Control Center Master/slave help

  1. #1
    Join Date
    11.04.2017
    Posts
    3

    Default Mitras LX7 GHL Control Center Master/slave help

    Hi all,

    I'm having an issue. I am trying to set up the master and slave for my mitras LX7 with GHL control center. When I place one on master channel 11(for example) and address 1 then disconnect. I then move change the other to slave channel 11 address 2 then disconnect. When I go back to check them they both say master same channel same address...everytime. What am I doing wrong? Thanks.

  2. #2
    Join Date
    07.04.2017
    Posts
    157

    Default

    Did you remember to click on the save changes button?

    Keep the both master and slave on ch 11 address 1 (in other words the same), click the save changes and try again. It worked for me

  3. #3
    Join Date
    11.04.2017
    Posts
    3

    Default

    Alekslyse,

    Yup, save, save, save...no dice. I had tried the same address same channel the first 50 times before I tried the same channel different address. No luck either way. :-(

  4. #4
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    What firmware version are these fixtures on?
    What version of GCC are you running?
    Have you tried to set each fixture to Master and Slave from the touch keys on the fixture?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •