Results 1 to 3 of 3

Thread: Network of Profilux 4 and Profilux 2 Plus Ex ???

  1. #1
    Join Date
    01.01.2015
    Posts
    26

    Default Network of Profilux 4 and Profilux 2 Plus Ex ???

    Is there any posibilities to connect two computers in one network: Profilux 4 (as a main board) and Profilux 2 Plus Ex (as a second).
    If YES (I hope so) how to do it?
    Which port I have to use in Profilux 4 and in Profilux 2 Plus Ex?

  2. #2
    Join Date
    06.02.2012
    Posts
    2,020

    Default

    Is there any posibilities to connect two computers in one network: Profilux 4 (as a main board) and Profilux 2 Plus Ex (as a second).
    That depends on your network.
    LAN/WLAN:Yes
    RS485: Yes
    RS232: No
    USB: No
    PAB: No due PLII has no PAB

    If it would be any combination of PL3/4 also PAB would be possible (with different device numbers)

    If YES (I hope so) how to do it?
    Why should you? There is no benefit. It´s not possible to communication in between, there is no possibility for failover, it´s not possible to share devices like powerbars or sensor values and so on - there is nothing. So it makes no sense to think about

    Additional info: The PLII isn´t supported by actual software (GHL control center) so it´s even not possible to use the same software to set the parameters.
    Last edited by Gunther; 13.04.2017 at 08:51.

  3. #3
    Join Date
    15.02.2018
    Posts
    2

    Default

    I am a ProfiLux 3.1 T EX user, and want to upgrade to your new ProfiLux 4, but the pronlem is how to run the P3 and P4 togther in the same system? Is it possible to set the system to make the new P4 as the main, and the old P3 as the extension box, at least, I don't need to throw the P3 away.
    Or it there any suggestion to combine the P4 and P3?

    Thanks, and waiting for your reply.
    Kelvin soong

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •