I cannot figure out how to connect 3 Power Bar 5.1's to my P4. The green LED just flashed on them and they are connected via the PAB cables. How do I add them?
I cannot figure out how to connect 3 Power Bar 5.1's to my P4. The green LED just flashed on them and they are connected via the PAB cables. How do I add them?
First, make sure at least 1 PB5.1 is connected to your P4. All others can be daisy chained off of the first PB5.1 or connected directly to the P4.
Once you've done that, do the following:
- Connect to your ProfiLux 4 using GHL Control Center
- Navigate to the System settings page and click on Assign devices
- Check the boxes for all 3 powerbars that pop up, click OK, confirm device assignment by clicking YES.
- Reconnect to your ProfiLux 4, go back to the System settings page and see that there will now be a PAB device option listed. Click the plus icon to the left of it and you will see your 3 PB5.1 devices listed.
Assign PAB devices.JPG
Next, assign socket numbering:
- Select the 2nd PB5.1, and click on CONFIGURATION, set the socket for this powerbar to begin at 6.
- Click OK
- Select the 3rd PB5.1, click on CONFIGURATION, set the socket for this powerbar to begin at 11.
I'm an idiot. I didn't have the PAB cable connected to the Power Bar. I have them all assigned now.
All of a sudden their disconnected from the P4 and I'm getting PAB errors. I can cycle power to the Power Bar and they come back on for a minute, then lose connection again. I've tried resetting the Power Bars and P4 a couple times but they won't stay connected long enough to connect to them. Any ideas?
I did the Profilux recovery and reset power to the Power Bars and now they are back on line. Weird.
They disconnect after assigning the 5th socket to my MH ballast. Is it something I'm doing out of order?
Maybe your ballast produces too heavy electronic noise. Try another, unswitched socket away from the Powerbar for test purposes.They disconnect after assigning the 5th socket to my MH ballast
If you test the powerbar, you also should keep as much distance as possible between PAB wire and the ballast line.
Bookmarks