Hi all..my p4 say "new" firmware available on his general page of GCC.
i go to system to start firmware update but click on button but never happen..
if i try to update touch or vortech controller update start correctly.
any ideas?
Hi all..my p4 say "new" firmware available on his general page of GCC.
i go to system to start firmware update but click on button but never happen..
if i try to update touch or vortech controller update start correctly.
any ideas?
I think the System page is for updating firmware of attached devices and not the P4. Go to "Extras" at the top of the page and click. To the left on the toolbar you will see "Firmware Update". Be sure tour PC is connected to the P4 via USB, then click on it.
That worked for me.
Bob
Steps for updating the ProfiLux 4 firmware can be seen here:
https://youtu.be/Fj0SH93QoKc
It certainly CAN work. I was a bit worried as the previous version was unable to save settings. Thankfully mine upgraded OK. I then instantly with the new version saved my settings.
All good so far. Sorry for your pain.
Hi
here are the emergency update instructions:
https://www.aquariumcomputer.com/dow...-instructions/
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
work to me so good in 5 minutes i had my p4 back.
mine too also after 2 attemps
Hi,
I'm trying to update the firmware of Profilux 4, everything is fine until this window comes out.
update firmware.PNG
What should I do?
In the video the window is removed immediately.
Thanks
Bookmarks