-
LEDControl4 V2 PWM output signal 1-10V or 1-5V?
I'd like to use a LEDControl4 V2 to control a set of DIY LED lights.
RapidLED asked me for the voltage of the PWM output signal. Is it 5V or 10V?
(The Meanwell ELN-P drivers need a 10V signal but the Meanwell LDD drivers need a 5V signal)
In the LEDControl4 manual it talks about a pullup 5V resistor - is this normally required on drivers like this?
Thanks for any help,
Mathew
Last edited by Raven900; 28.11.2016 at 07:22.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks