Results 1 to 4 of 4

Thread: Dose 0.1mL

  1. #1
    Join Date
    22.08.2016
    Posts
    3

    Default Dose 0.1mL

    The GHL website claims that the Doser2 is capable of micro dosing at 0.1mL. I cannot, for the life of me, get it to dose any volume smaller than a full mL.

    Am I doing something wrong? I calibrated the specific pump, at a speed of 0, and the gross calibration amount is 5mL per minute.

    Thanks

  2. #2
    Join Date
    27.05.2015
    Posts
    2,488

    Default

    After setting the speed and calibration, did you enter the amount of fluid that was dispensed?

    Settings must be saved after entering the new flow rate of the pump.

  3. #3
    Join Date
    22.08.2016
    Posts
    3

    Default

    Thanks for the reply Vinny. Yes, I clicked the save button after each step of the setup. If I set the volume to be dispensed as 1mL, then it will dose without issue. But, when I try to set up a .3mL dose, of ZeoStart, it will not dose that amount.

  4. #4
    Join Date
    22.08.2016
    Posts
    3

    Default

    So, any suggestions for why the Doser 2 will not dispense anything less than 1mL?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •