Error to low firmware to use GCC

[Reefwiser1]

So I was able to update to 6.23 firmware.
When I booted into the GCC software it showed a firmware update available so clicked on update firmware and selected the 6.24 firmware. But while it was erasing the flash it gave this error.


Next step is updating my 3 PAB powerbars.


Sent from my iPhone using Tapatalk

[Reefwiser1]

How do I upgrade the firmware to 6.27 which I see some people using?
Also having fun setting up myGHL. 😀

Sent from my iPhone using Tapatalk

[Reefwiser1]

If I use this version of GCC https://www.aquariumcomputer.com/dow...nter-v1-0-8-5/
Should I be able to upgrade to the lastest firmware?

[Vinny]

Each time you wish to update to the latest firmware, you must download the latest version of GHL Control Center which is the link you provided above. The newest firmware will be included in the download.

Before doing the update, make sure you've saved all your controller settings and sensor settings to a file. Once you've done that, uninstall the previous version of GCC and install the new version. Run the new GCC version and click on the Extras tab, then Firmware update.

[Vinny]

To setup myGHL, you must do the following:

- Have the ProfiLux connected to your network.
- Enable myGHL in the System settings page
- Log into your myGHL account and add a new device
- Enter the myGHL-ID shown in the System settings page into the myGHL field, click verify.
- Copy the security key as shown in the System settings page and paste it into the myGHL field.

*If you don't see a security key after clicking verify, click on Update view in GCC, the key should then show up.

[Reefwiser1]

Thanks will do it tomorrow afternoon.


Sent from my iPhone using Tapatalk

[Reefwiser1]

So finally tried to setup myGHL.
went to the system tab in GCC. An clicked on myGHL is enabled,full access read and write.
Logged into myGHL
put the myGHL ID number from the system tab.
Then clicked on Verify.
I then get a dialog box that says
www.myghl.com says:
Device is not connected to myGHL
An the a Ok button.
Nothing happens.
What am I doing wrong. 😀


Sent from my iPhone using Tapatalk