Originally Posted by
CaptCrash
This may not be the correct information as I don't have a Gen 1 Slave Doser, but I did help set one up a few years ago.
Connect with GHL control centre to your Profilux
Go to the System-> socket functions page
Make sure the Digital powerbar connected on S1-S4 (outputs 1-24) is ticked.
click save
Connect your doser and nothing else to the S1-S4 port.
Click Program digital powerboat or dosing pump unit...
Select Numbering of a dosing pump
Select the starting number you want to use for the dosing pump (if you have no sockets then 1 to 4 is fine. If you have 2 powerbar 6's using 1-12, then select 13 to 16 for the dosing pumps).
Click next then program now.
Click save changes if it is black.
Click disconnect
Click connect
You should now be done, hopefully you should have communications lights on the dosing pump now.
To test if it works
Assuming you set your doser to 1
click on Activate Manual Override
Turn on socket 1,2,3 and 4.
As you do so each loser should turn on.
Bookmarks