Slave Doser 2 updating FW and connecting to P3

[Vinny]

You can set it to "1".

That means that your doser will respond to the programming assigned to "Dosing Pump 1, 2, 3, 4".

[doggydoc10]

Where do I find the FW for the Doser 2 update?????


Always at Sea

[Vinny]

It is included with the latest version of GHL Control Center. If you go to the GHL Control Center folder, it will be in a folder called "Firmware".

Both standalone and slave version is there so make sure you select the correct one.

[doggydoc10]

I looked under Download and FW and only found FW for GHL Control center. Couldn't find anything that said Doser.



Always at Sea

[Vinny]

On your PC do this:

1. Go to "This PC"
2. Select "(C: )" - Your hard drive
3. Select "Program Files (x86)"
4. Select "GHL Control Center Vxxxx - The latest version of GCC
5. Select "Firmware"
6. Select "GHL Doser 2 Slave"

The firmware file is there.

[doggydoc10]

Ok. Thank you.
Found it. But when I select it and go to update....
This happens.



Always at Sea

[doggydoc10]

Never mind.
Got it to update.
BUT it can't be done from tabs on GHL at the top where it says "Extras" and FW Update like you mentioned early. Or at least didn't let me do it that way.
It HAS to be done via SYSTEM tab FW update
👍🏼👌🏼👍🏼

THANK YOU Vinny


Always at Sea

[doggydoc10]

Next question here. How do I get the Doser connected to MyGHL? I have it connected via GHL control center but how do I get it to connect to the app?


Always at Sea

[doggydoc10]

Next question here. How do I get the Doser connected to MyGHL? I have it connected via GHL control center but how do I get it to connect to the app?


Always at Sea

Anyone?


Always at Sea

[Vinny]

The slave version cannot be independently controlled via the smartphone app because it does not have the built-in wifi like the standalone version. In order to access your slave doser over myGHL, you would first have to add your P3 to myGHL and view the doser settings from there.