Hi Idid a full factory reset and was able to setup correctly.
Type: Posts; User: pjcook
Hi Idid a full factory reset and was able to setup correctly.
HI
I am having lots of issues trying to get my Lightbar2 Daylight.
I am using the splitter, communications cable plugged into the Digital Light Controlled Interface.
I have managed to get...
Could well be the case as I was using the unit previously on a marine tank, there was no message that the calibration had failed but I take your point. I will order a new probe and see if that sorts...
Hi
I have run the calibration twice and still the same issues. The unit is about 2 years old. The ADC Values are ADC 1: 530 ADC 2: 522
I have just calibrated my PH probe for freshwater, I set the first level to 4 and used calibration solution 4 and the second level to 7 and used calibration solution 7. All went well with the...
Hi Mathias
I suspected that would be the case, it is not a big issue as I can do most things from the remote function using the software. One further question, can I do firmware updates safely...
The display on the unit is corrupted. I can read some of the words OK, but when trying to configure the unit it is impossible to read everything correctly.
I did a factory reset, but that did not...
Thanks, can you also advise if a firmware update may help fix the display issue?
I have just hooked up my profilux Plus II to my freshwater tank after it had been in storage for 6 months. Previously it had been calibrated for a saltwater tank. My problem is that the profilux...
I purchased and istalled a Powerbar 6D onto my Profilux Plus II. Initially it worked fine until last week. The powerbar now does not seem to be communicating with the computer. 1 Outlet S3 is...
Hi Matthias
I have received the replacement LAN card today, installed and connected first time without a hitch.
Regards
Peter Cook
Hi Matthias
I agree, I have returned the card to my retailer, he is going to return it to be checked.
Thanks for your assistance.
Peter
I have plugged the LAN card into the same slot the USB card was in and still unable to connect. I have also tried all of the other slots as well.
I have assigned a static ip address of...
OK, I found a computer with a Serial port and was unable to connect using the serial port either. I have done a complete factory reset on the profilux and the serial port and USB port are now...
I have tried it using both WinXP and WIndows 7 RC. The USB connection worked perfectly until I removed it to install the LAN card. I re-installed the USB Card so I could use the software while I...
[QUOTE=aqua_digital;1655]Then you need a cross over cable to connect directly, it will not work without[/QUOTE
I did use a crossover cable when I directly connected
As per original post, I have directly connected to the profilux LAN car with no routers or firewalls involved, still unable to connect.
I have tried to connect using the USB interface I previously...
No I did not change the Baud rate at all.
I have changed the configuration to 10 Mbps and still cannot connect.
If the card is plugged into the middle slot on my profilux what Device Address...
I am having a similiar issue to other users in trying to connect to the profilux II unit over my LAN.
I installed the LAN card into Slot 1 and configured the card with an ip address of...