Search:

Type: Posts; User: samwise

Search: Search took 0.00 seconds.

  1. Thread: Sensor output

    by samwise
    Replies
    4
    Views
    8,318

    @MatthiasF - Could you specify how to interpret...

    @MatthiasF - Could you specify how to interpret that format? Source-id, Source name are naturally clear, but details, value 1 (seems to be measurement value to be divided with 1/10/100 depending on...
  2. Communication error #28 present with Wifi and LAN

    Hi,

    So what is the most up-to-date advice to deal with this? GHL Control center ends up in communication error 28 with 100% certainty in about 5-20min of being just open. Connection is with Wifi...
  3. Replies
    19
    Views
    23,639

    Hi, and thanks for your answer. No I don't...

    Hi, and thanks for your answer.

    No I don't have direct access to another test kit, but this is not expired one. It is valid until end of 2020 and opened just few months ago. And I did not notice...
  4. Replies
    19
    Views
    23,639

    Hi, Unfortunately I need to report the similar...

    Hi,

    Unfortunately I need to report the similar behaviour of KH director, something that makes "adjust displayed measured value " correction hard to use. Specs of the installation below:
    - Reagent...
  5. Connecting two temperature probes to Profilux 2 Plus Ext... how?

    Hi,

    Trying to figure out how to connect two temperature probes to Profilux 2 Plus Ext computer. Does split cable work like it works for level?

    Or does PLM-pH-Redox-DigTemp Sensor (PL-1258) and...
  6. Connecting two temperature probes to Profilux 2 Plus Ext... how?

    Hi,

    Trying to figure out how to connect two temperature probes to Profilux 2 Plus Ext computer. Does split cable work like it works for level?

    Or does PLM-pH-Redox-DigTemp Sensor (PL-1258) and...
  7. Thread: Redox probe

    by samwise
    Replies
    7
    Views
    4,563

    Ok, thanks. Signal filter is different thing from...

    Ok, thanks. Signal filter is different thing from the calibration tolerance? Haven't seen that kind of an option anywhere, in which firmware version that should be found?

    Sami
  8. Thread: Redox probe

    by samwise
    Replies
    7
    Views
    4,563

    Redox electrode went crazy

    Hi,

    I have exactly the same problem with my redox probe. Clean and calibrates perfectly, readings are stable in any vessel of water except my aquarium. Swings 20-30 mV all the time. This started...
Results 1 to 8 of 8