is there service center in the us? or do I have to replace the profilux controller?
Type: Posts; User: ballhog
is there service center in the us? or do I have to replace the profilux controller?
So I disabled all the probes, saved the settings, then enable the probes. Conduct and Redox did not move at all. Conduct =0 and Redox = -827. The temp probe value changed by 2 degrees to 95.2 F,...
Sensor active is selected for each of the sensors. I have checked how the sensors are connected and tried using the calibration fluid. The sensor readings do not seem to change on the probes. I...
My profilux was disconnected and packed away for 6 months. I've recently tried to setup the controller up again, but the temperature and conductivity probes seem to be displaying incorrect values. ...
Ive had my dose 2.1 for about 8 months, recently the status logo has been solid red. Seems to clear when I cycle the power. When I look this up it says memory failure. Should I be concerned about...
Thanks for the help, I will update the firmware tonight and give it another try.
I am setting up a new doser 2. I am unable to get the wifi or myghl to work, but I can connect to the Doser over Lan using the computer or phone app. Using the Lan, I am unable to connect to...