Hello All.
I run the P4 on my main system but was looking at the mini for my nano.
Only thing is I need a level sensor option.
Would this be possible using the L1 1-10v ports.
Any advice would be...
Type: Posts; User: TYC2012
Hello All.
I run the P4 on my main system but was looking at the mini for my nano.
Only thing is I need a level sensor option.
Would this be possible using the L1 1-10v ports.
Any advice would be...
Hi Vinny
Thanks for the info I thought it might be through the co2 but clarification is much appreciated.
One more daft question is there a specific kH a calcium reactor produces at a certain pH or...
First let me apologise if this has been posted before but I can't find it.
I want to control a calcium reactor with kh director and have looked at the manual but I'm still confused (lol)
Does the...
The kind people at dsuny sent me the pin out as follows
1R =34vdc + to power controller ?-- yes, ( input). the power is from the light panel.
GND = GROUND
2B = CHANNEL 1. 0-4VDC
-- (out...
Here we go this is what I plan on doing !!!
Desolder the channels off the control unit completely and sconnect them to the pins as you described.
I'm assuming ???? 6Y is the pwm negative so I'm...
The channels are as follows so I'll double check which one is which .9645
Thanks again.
Each individual unit has its own (the brick says 38vdc) on it but it runs at 34vdc.
If you actually take the controller off the lights stay on at the last setting so I think the 34v +...
1st pic controller
9641
2nd pic light controller side
9642
3rd pic
Light daisy chain side
9643
Well i took it apart and this is what i found.
I have 3 pics.
The first one is inside the controller. The second is the light on the controller side and the 3rd is the light on the daisy chain...
Its as easy as that Pit ?
Hello everyone I'm after knowledge and help from the community.
I have 4 dsuny led panels and want to control them using the 0-10v control from a profilux 4.
I asked the maker for some technical...
Hello everyone I'm after knowledge and help from the community.
I have 4 dsuny led panels and want to control them using the 0-10v control from a profilux 4.
I asked the maker for some technical...
Thank you for your reply.
Shame I was hoping for a space saver :-)
Hello All,
Sorry if this has been asked before but I've been trawling through page after page but can't find anything!
I've seen a GHL magnetic solenoid and wondered if this would be used to...
Hello All
So there's the big news about the Kh director so when can we get our hands on the elusive item :-)
Hope its slightly less expensive than the KHG lol:D
Thanks Vinny,
Do you think I would be able to test the multi plug on this to see what voltage it transmits to the light and it what sequence ?
First let me apologize if this has been asked before or is a dumb question (i'm new to the profilux 4 and its capabilities and to technical wiring. There's a lot of abbreviations used that baffle me...