Hallo
ich habe ein Ticket für Sie erstellt:
https://www.aquariumcomputer.com/de/support/tickets-anfragen/
Melden Sie sich mit der gleichen E-Mail-Adresse wie im Forum beim Ticketsystem an....
Type: Posts; User: Gael
Hallo
ich habe ein Ticket für Sie erstellt:
https://www.aquariumcomputer.com/de/support/tickets-anfragen/
Melden Sie sich mit der gleichen E-Mail-Adresse wie im Forum beim Ticketsystem an....
The controller is the Profilux - the expansion box simply follows the controller's commands.
To be clear, the ProfiLux 3 (released in 2009), will not be getting any new software updates to support...
The only way to use Mitras Lightbar and Mitras Slimline on the same ProfiLux is to add an Expansion Box 2.
One can be connected to the ProfiLux and the other to the Expansion Box2 .
It is in fact...
Hello,
Unfortunately this error has been unintentionally copied from the Mitras lightbar 2 product page.
The Mitras Lightbar 3 cannot be used with the ProfiLux 3.
The page has been...
Hello,
If you want it to be 20%, set the maximum to 20% instead of 100%.
Gaël
Hello,
Unfortunately this is not possible.
However, if your lighting can be controlled via PWM, you can use our “LEDControl4 V2”.
Gaël
Hello,
To update the wifi module firmware, I suggest you use the emergency web interface.
To do this, go to http://1.2.3.4/update/ (replace 1.2.3.4 with the real local IP address of the ProfiLux,...
Hallo,
Mitras Lightbar 3 hat eine noch höhere interne Dimmauflösung (1 : 16000) und zudem andere/neue LED Farbkanäle, Mischbetrieb leider nicht möglich.
Die Software verlangt die Auswahl...
Hallo,
Die Software verlangt die Auswahl zwischen Mitras Lightbar 1/2 oder Mitras Lightbar 3, daher ist es nicht möglich, sie zu mischen:
13615
Gael
Hello,
In the link I gave you https://www.aquariumcomputer.com/knowledge-base/level-control-and-leakage-monitoring/ all 8 modes are explained.
Use the "Leakage detection" mode.
Activate push...
Hello,
You don't need to worry about data storage, the storage in ProfiLux is just a buffer zone before storage in myGHL, it will never be full because the oldest values are automatically erased...
Hello,
the pH4 calibration fluid is not missing. In fact, as indicated on the ProfiLux 4 Mega-Set 6E product sheet https://store.aquariumcomputer.com/profilux-4-mega-set-6e-2/ are included:...
Hello,
Don't do that, the IOND and the KHD don't work the same way.
The KHD empties its sample tube at the end of the test, whereas the IOND sample tube remains permanently full.
Gaël
In water:
13614
An infra-red LED and phototransistor accurately positioned at the base of the sensing tip ensure good optical coupling between the two when the sensor is in air. When the sensing...
Hello,
13613
The sensor is of the NC (normally closed) type, sending a signal at all times except when water is detected.
This also allow to trigger an alarm if the sensor is disconnected.
...
Hallo,
Kann es sein, dass eine Ihrer Sicherheitssoftware, wie z.B. Antivirus, den Start blockiert?
Sie können ein Support-Ticket eröffnen, damit wir uns gemeinsam über eine Fernwartungssitzung...
Hello,
The pop-up has a "more info" button that opens the following article did you consult it it indicated that you must have firmware 6.50 for your ProfiLux3:...
Hello,
I see several inconsistencies here.
The ProfiLux 4 has no Ethernet LAN port.
The ProfiLux 4 cannot work with firmware as old as 5.02.
The ProfiLux 4 has a WiFi ESP module that handles...
Hello,
No, all 4 LX will follow the same program, BUT:
-> It is possible to define an offset in the execution of the illumination program, in order to create a sunrise/sunset effect, using the...
Hello,
I just checked with iOS 15.8.2 and GHL Connect 3.26.6 and I don't see this problem.
Have you tried reinstalling the application completely?
Gaël
Hallo,
Leider nicht, wie bereits gesagt, wir werden in Kürze weitere Details wie Preis und Verfügbarkeit des GHL Futterautomaten bekannt geben.
Melden Sie sich gerne hier für unseren Newsletter...
Hallo,
Bitte eröffnen Sie ein Support-Ticket.
https://www.aquariumcomputer.com/de/support/tickets-anfragen/
Gaël
Hello,
You need to connect to the Doser via USB and use the GHL Control Center software.
Gaël
Hallo,
Bitte eröffnen Sie ein Support-Ticket, damit wir Ihnen direkt helfen können:
https://www.aquariumcomputer.com/de/support/tickets-anfragen/
Gaël
Hallo,
Der Standard-Benutzername und das Standard-Passwort für das Webinterface sind:
admin
Starfish
Bitte eröffnen Sie ein Support-Ticket, um persönliche Hilfe zu erhalten.
Gaël