Printable View
Hi! I had a faulty tempprobe that showed 0 C and that did that the heater never switched off. I saved the fish becasue the temp reached 34c before I could stop it.
I would like to program so the heatersocket switches off if the alarm goes off on the tempprobe. I tried with the programable logic but i cant figure it out.
Help plz :)
you can test it with this config
Attachment 9918
Attachment 9919
regard Pit
Thx will try
Skickat från min G8141 via Tapatalk
1. Go to the TEMPERATURE settings page.
2. In the ALARM section, select ACTIVE to activate the alarm feature for this probe.
3. Select YES for Deactivate control.
5. Set the maximum allowed temperature deviation.
4. Click SAVE CHANGES.
This will turn off the assigned powerbar outlet in case the temp reading is outside of the allowed deviation.
This is what i want. Thank you. Vinny i emaild your support and they didint know this.
Skickat från min G8141 via Tapatalk