Updated the firmware to 7.10. So that works. Also tried to update the wifi on a different computer (win10). Same problem.
Update: Installed Windows 7 and tried it again. Same error...
Printable View
Updated the firmware to 7.10. So that works. Also tried to update the wifi on a different computer (win10). Same problem.
Update: Installed Windows 7 and tried it again. Same error...
More problems... I updated to 7.10. Now the temp is off. I have a manuell tempprobe that always have been in sync with the profilux. Now after the update the profilux reads 2 C to high. The p4 is reset with factory settings then the settings is imported via file. This is both direct on the p4 and my exbox 2, so on two different tanks. What to do?
Update! I did a reset on the p4 and disconnected all pab and did a reset in the pab. Redid all settings (no backup). Then added pab one efter one. Allso now the exbox 2 is last in the chain. The p4 now show the correct temp. The exbox still is 1,3 C to high. I allso swapped the tempprobes. Same values so its the exbox 2. Tested before and after I updated the exbox with new firmware. Still the same.
Yes I have. But why is it wrong? The profilux should have the right readings...
Skickat från min G8141 via Tapatalk
Something is very wrong. When i upload the firmware and then reboots the profilux the wifi redy is checked. module version is 0. When i reupload the file system the filesystystem ok is checked and firmware is 6565. BUT. The wifi dosent start. I have all the settings. If i reboot the profilux its back to no filesystem and module 0.
we take this to 2nd level support
please email GHL
I've emaild the support now
Skickat från min G8141 via Tapatalk