-
Min max level
Hello,
I would use min/max level with 2 sensors (4 et 5 for me)
what is the command corresponding with the action ?
i test "water fill 4" and 5: not working
i test "water fill (ato only) 4" and 5: not working
I want to start a pump when the minimum level detect and stop when the maximal level is detected
the pump is connected on powerbar (s13), how to start it ?
PS Excuse me for my bad english... :(
-
-
Hi,
take a look at "Probe/sensor controls->Level". You can add a level-control there and assign it to your switch channel.
Should be something like
level-control 1: mode min-max-control with sensor 4 and 5
switch-channel 13: fill water (ato only) with control 1
-
Thank you very much, it work fine
I tested fill water (ato) but with the numbers of the sensors not the number of level-control
Thank :)