After Upgrade to 1.09 firmware my temp sensor showing 40 C.
Before I was 1.06 firmware, anybody have that and can share me ?
Or expalin why any update EB1 is fail ?
Printable View
After Upgrade to 1.09 firmware my temp sensor showing 40 C.
Before I was 1.06 firmware, anybody have that and can share me ?
Or expalin why any update EB1 is fail ?
did you re-assign the EXB to PAB?
Yes
please post a screenshot of
- System, where the EXB details can be seen
- temperature probe in question, where ADC values can be seen
you writebut the screenshot shows 1.08 for the EXB FWQuote:
After Upgrade to 1.09
besides this, the ADC-values are wrong, they should be loaded from the EXB after assigning the PAB
so please do this:
1. PAB system reset
2. reboot controller
3. assign again
if the shown firmware version is still not 1.09 do the PAB update again
connect only the EXB during update to PAB
both