Profilux 3x restarting

Hello guys
I have a problem with my profilux 3 computer, it keeps restartin on and on
when I power it up it does all the tests and when the fish goes to the left, it is restarting

Can you help me in any way?
Thanks a lot

Does-it happen when all cables and expansions cards are removed, with just power cable?

Had anything changed in your setup? Is the 12v power supply still being used?

Please take a look at the green light on the power supply and let us know if it is solid green or flashing.

Yes it happens with all the cables removed! I have no green light on my 12v power supply
It happend when I pluged the led driver of my Mitras light bar into the socket
Can I make a hard reset of the computer?

Quote:

---

Originally Posted by Flash4x4

Yes it happens with all the cables removed! I have no green light on my 12v power supply
It happend when I pluged the led driver of my Mitras light bar into the socket
Can I make a hard reset of the computer?

---

If its no light maybe the power supply is broken. You can hard reset the P3 with the emergency update. That would reset the device completely so have a backup. Instructions is found in the download section.

No problem with the power on profilux, it is starting but after it boots, it is restarting. There, on the power source is no led, no light

Here is a movie of it
https://youtu.be/f6b9QITLJPM

Quote:

---

Originally Posted by Flash4x4

Here is a movie of it
https://youtu.be/f6b9QITLJPM

---

Seem to me like a defect power supply. Did you try to hard reset it?

I read the instructions on reflashing, but I can not download de file . Zip. It says 404 not found.
I saw that inside the case there is a button called Reset, how can I use it?

Quote:

---

Originally Posted by Flash4x4

I read the instructions on reflashing, but I can not download de file . Zip. It says 404 not found.
I saw that inside the case there is a button called Reset, how can I use it?

---

Here is the flashing tool: https://www.aquariumcomputer.com/dow...cy-flash-tool/

If you use USB just follow the last part of the guide. Set the jumper correctly, start the flashing, then press the reset button when the application ask and wait for it to finish.

Did that now, everything is the same.
No improvement

Thanks a lot for your advice
Maybe form GHL will come another solution

I think you need to try a different power supply to rule out a fault with it .

To me it looks like a psu fault

Ups, you might be right till some point.
I started Profilux with another power source, I reseted to factory settings and now it works well with the original power source
I do not know what happend but I think I will send it to GHL to sort the problem with dimming the Mitras LightBar 1