ok plugged it into the linksys and it found it and said I configured it to my network. I see a new device listed in the network now also internet gateway device is what it says. So what steps do I take from here? Should I remove the wlan card now?
Printable View
ok plugged it into the linksys and it found it and said I configured it to my network. I see a new device listed in the network now also internet gateway device is what it says. So what steps do I take from here? Should I remove the wlan card now?
connect the lan port of your P3 to your bridge via a lan cable.
Yes I have done that. I think I probably need to set up ip's or something. Do I ever need to connect the p3 up with the pc or router to do anything?
I think its important to repeat your network setup and tell us which components you currently have connected to your network
for example:
and tell us how you want to have them connected via wifi / cable etc...
my network setup ( for my profilux is like this )
internet => external wanport router => internal network router => wifi to laptop ip 192.168.0.200
internal network router => cable to profilux ip 192.168.0.100
so you can see that my router is connected to the internet , it has wifi to connect to my laptop
and I use a cable to connect to my profilux , in this way my laptop can connect via wifi to my profilux ( goes via router , via lancable to p3 )
currently we have no view on which connections you want to make ( which ones with cable , which one with wifi , etc... )
currently I have a linksys wireless router to run the wireless network. I have a printer on our network. A couple laptops and our iphones phones, ipad and then the dlink. I want to connect the dlink to the p3 like I have it now with ethernet cable. I want to be able to check on the profi from remote locations and stuff like that. Also maybe be able to change settings and stuff. I currently use the wlan to connect to the p3 from my laptop.
if we know what you want to make then this could be handy ( I used to have an Dlink gaming router )
and made this procedure to get you going.
pffff can't upload it to the forum since they don't alow PDF :(
so you can't make an wired connection from your P3 to your linksys router ( it has no ports ? )
so If I understand correctly
=> you want to use your dlink router as a 'bridge' to connect to your wifi linksys ? and then your P3 via the bridge to your network
also plz specify your dlink brigde type ( we can have a look in the manual )
no the tank is on another floor of the house then the router so I can not hard wire it. I am using the DAP-1522 Xtreme N Duo Wireless Bridge/Access Point
I've checked the manual of your router
and you need to execute the steps from page 48 ( when your in the login => jump to page 53 ( manual setting up the router in bridge mode ))
if you need to select your SIDD you need to select you current network of your linksys ( and give in that private key )
then you need to connect your P3 to your bridge
and if if its default , connect to your bridge and since the P3 is setup for DHCP per default , you should be able to view the P3 in the web interface of your bridge.
(while setting up the bridge router is best to connect your computer via wired )
The manual for the linksys or dlink? Now I am getting confused.