I noticed in the night setting you have simulation on at 10pm(22) and ending at 12 noon. that is if you are using 24 hr clock
Printable View
I noticed in the night setting you have simulation on at 10pm(22) and ending at 12 noon. that is if you are using 24 hr clock
not sure what you mean. The software (profilux control) will always go to default untill connected. Also did you save the settings to the mitras then it will be in the controller on the mitras..
sorry I should of said GHL control center( software for the mitras)
Sorry, right, when the longdatude and latitude are set to my house, then saved and updated, the next time I connect to the lamp, they have both reset to 1, now, my question is, if this is happening like it is, how does the mitras know what the moon phase is.
As is happening, the lunar cycle can't run properly as the lamp has no reference point to work to surely.
Gazz
longitude and latidude are not used at all at the moment, this is for future simulation functions
this does not affect the moon phase calculation!
because the moon phase (full ... new) is the same all over the world
ok, is there anyone that can post some screenshots of a typical light run to include moonlighting as a few of us are still seeing problems in this area, i have all but given up on moon lighting and just run a blue at 2%, but i would like to use the moonlight function as it is there to be used.
or better still, could someone please email me a copy of their program where the working moonlight is a definate.
nobody using moonlights:confused: