For some reason i can only run two option "permanent" and "perm opposite".
All other options will stop them.. any clue?
Printable View
For some reason i can only run two option "permanent" and "perm opposite".
All other options will stop them.. any clue?
^ anyone can help :o
too lees information to help, we need some more details
better you post your relevant settings, e.g. as screenshots
I am not sure why with this configuraton both pumps are not working and why one have 0 % state
http://i27.photobucket.com/albums/c173/mshur/se1.jpg
http://i27.photobucket.com/albums/c173/mshur/ran.jpg
if you choose "sequence" or "random" then the pumps are activated in turn with a certain pattern, not all are at the same time on, please read the manual regarding the several modes
in your settings this state changes every 30 minutes
-> it is normal and correct that a pump is off
if you want all pumps permanently on you must use mode "permanent" or "permanent opposite"
they are explained in the manual, too
are the 1-10V-interfaces adjusted correctly? screenshots?
Is it normal that one of the pumps have 0 % state? And why then they both "dead". How can i set up that they wouldnt go to 0% state? Both pumps set to 3-8 v.
if you don't want that pumps are temporarily off then you have to use the mode "permanent" or "permanent opposite", I don't know what else I could add now
hm.. so, there is no way to set it that pumps will not go completely to a 0 state on seq-1 mode? my point is when one pump goes to 0 state for some reason they both "dead". i understand if one working and one off, but why they both off?
set to 1% as i said in the email
http://i27.photobucket.com/albums/c173/mshur/se1-1.jpg
set it to 1% , one pump have 0 state and they both "dead"