Connecting Mitras to MyGHL not working

I am trying to get my myGHL ids that are associated with each of my LX7 fixtures verified and recognized by myGHL. In following the manual, it demonstrates connecting a doser to myGHL, versus an LX7, via GHL Command Center (GCC) and specifies navigating to a system menu with a myGHL active checkbox. However, when I connect my LX7 to the GCC I cannot locate a system menu nor a myGHL active checkbox. I do have, however, unique myGHL ids for each of my LX7s. So my question is how can I register my LX7 in my GHL?

Hello nycman,

the myGHL settings can be found in GHL Control Center, when you navigate
the "Communication" page:
Attachment 9448

The rest is, as you already mentioned, according to the Doser2 setup.

Hi there. When I go to MyGHL and attempt to add a device by entering its MyGHL ID, I get a message that says "This site says... Device is not connected to MyGHL". And in the connection section for the light in GCC the security code is ---.
Attachment 9450Attachment 9450Attachment 9450

Hello nycman,

the more relevant networking configuration parameters are in the lower section of this page.
Gateway-IP DNS-Server-IP and status checkboxes are important, in order to communicate with the myGHL-server.

Post these, too.