Calibration loss

Hello
I noticed my doser2.1 after a few days
Loses calibration in particular pump n. 3
even when dosing in manual and slow ... in a minute ago about 10 ml ..
To make it work well, I have to rewrite in gcc , And calibrate everything again
And after 2-3 days Same problem


thank you

Hi,

Are you calibrating the pump, entering the amount of fluid dispensed, and saving your settings?

What is the pump speed set to?

Quote:

---

Originally Posted by Vinny

Hi,

Are you calibrating the pump, entering the amount of fluid dispensed, and saving your settings?

What is the pump speed set to?

---

Hi vinny. Everything is calibrated and saved
Pump 1. (fast)
pump 2. 2.
pump. 3. 2

Just set it all ok
Then after a few days, the pump 3 Does max 10 ml per minute

If you calibrate pump 3 in gcc. Even calibration takes 10 ml per minute

I have to set the factory to have the right calibration again

Before starting the calibration, you need to select the desired pump speed then click save. This will set the motor to run at the desired speed. Once that is done, begin the calibration

Also check to see that your doser is running on the newest firmware version.