Doser defaulting back to S1-S4 after power outage
Hi, I have two PAB powerbars and a 4 channel doser, PAB bar 1 is S1-S6, the doser is S7-S10 and the second PAB bar is S11-S16; this has been setup this way for a long time however after a brief power outage today dosing pump 1 came on permanently - I only noticed this as I was passing the doser at the time of the outage. Luckily dosing pump 1 is not connected so no damage was done but if it had been doser 2 that would have been dumping about 10L of alk solution! On further investigation, manual override of S7-S10 had no effect, however, manual override of S1 switched it off....S1 is my return pump. I had to reprogram the doser back to S7-S10, my question is how can this happen, in all the time I have had a Profilux it has only ever gone wrong when flashing....If I hadn't been present this would have been a tank wipeput - should the doser be set to S1-S4 always and PAB plugbars set after? Please advise, Andy