PDA

View Full Version : Firmware 6.00 für ProfiLux 3



Matthias
13.11.2013, 10:22
ist nun als Release-Version verfügbar

Änderungen gegenüber Beta:
- 2 Funkmaster (PLM-PWC und Mitras) führen nicht mehr zu Kommunikationsstörungen (dennoch: bei Verwendung einer PLM-PWC müssen auf jeden Fall alle Mitras als "Slave" eingestellt werden!)
- Zeitzonen im Webinterface korrigiert

Achtung: Zur Bedienung eines P3 mit Firmware 6.00 ist zwingend ProfiLuxControl 6.x.x.x erforderlich

Das Update von Firmware 5.xx auf 6.xx aber mit ProfiLuxControl 5.x.x.x durchführen!

johnbaker
16.11.2013, 12:58
Cannot update from 5.17 to new 6.00.
Have downloaded profiluxcontrol v6000, which loads but it cannot connect and I get this message 5132
when I try to install profilux3 V600 I get this message 5133 and when I select the profilux and it loads version 5.03.
How do I update my system, I am using a usb cable to connect to the profilux.
Thank you in advance.

spacyboys
16.11.2013, 13:02
Hey Johnny,

all you need to do is connect with the old client PLC version 5.xxx in order to flash your firmware.

hope this helps,
Daniel

johnbaker
16.11.2013, 13:32
I do not know what you mean. I am not that good on a computer.

Gunther
16.11.2013, 16:32
To update a PL with Firmware 5.x you have to use ProfiluxContol 5.x due ProfiluxControl 6.0 isn't able to connect PLs with Firmware 5.x

Remark: The update is only neccessary if you have one or more Mitras and the new PLM-PWC card. Without this card it's not neccessary (there is nothing else updated)

And by the way - this is the german part of the forum. Please use the english part for questions in english.

GHL_2013
17.11.2013, 16:44
Hallo,
ist das normal, das die Virtuellen Sensoren gelöscht werden?
Auch wenn man die Sensordaten wiederherstellt?

mfg
GHL_2013