View Full Version : Need to recalibrate sensors after 5.00j
JasonMcK
31.01.2010, 00:09
Just wondering if anyone else has found it necessary to recalibrate all sensors after upgrading firmware to 5.00j on the PIII
Thanks
J
I haven't upgraded yet, but do we need to use new calibration fluid if we do?
I thought that the calibration fluids were a one time use only thing.
Mitch
Matthias
01.02.2010, 09:11
Hi
if you are talking about sensors which are connected to the expansion box - yes
the sensors which are connected to P3 need not a new calibration
you can use the fluids many times - if you clean the probe before immersing
JasonMcK
01.02.2010, 16:27
Hi
if you are talking about sensors which are connected to the expansion box - yes
the sensors which are connected to P3 need not a new calibration
you can use the fluids many times - if you clean the probe before immersing
Strange, PH and SG sensors changed after the upgrade.
These are directly connected to the PIII.
Not a big deal just thought I'd mention it
J
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.