Jof
24.01.2010, 19:59
Hello,
Never used a controller such as the Profilux, but would now like to do so.
I'm thinking of the Light II Controller. My requirements are to:-
1) use optical level for auto top up.
2) operate pump for auto top up.
3) control & operate dimming of 1 x Aquaray, (via led module).
4) control & operate Simuli stick.
5) control & operate dimming ballast for 2 x 54w T5's, (via DALI ballasts)?
6) temp control to operate chiller switching.
If all this is possible, I'm not over sure on the T5 ballast point. My thinking is that I can replace my old non-dimming ballast with a DALI ballast, using the two 1-10v wires from the DALI ballast directly to the 1-10v channel on the controller??
I'm aware the capabilities of this unit are limited compared to the rest of the range, but as I don't need readings of other parameters or to operate any other equipment I'd like to keep it as simple as possible.
Any help / advice will be much appreciated!
Never used a controller such as the Profilux, but would now like to do so.
I'm thinking of the Light II Controller. My requirements are to:-
1) use optical level for auto top up.
2) operate pump for auto top up.
3) control & operate dimming of 1 x Aquaray, (via led module).
4) control & operate Simuli stick.
5) control & operate dimming ballast for 2 x 54w T5's, (via DALI ballasts)?
6) temp control to operate chiller switching.
If all this is possible, I'm not over sure on the T5 ballast point. My thinking is that I can replace my old non-dimming ballast with a DALI ballast, using the two 1-10v wires from the DALI ballast directly to the 1-10v channel on the controller??
I'm aware the capabilities of this unit are limited compared to the rest of the range, but as I don't need readings of other parameters or to operate any other equipment I'd like to keep it as simple as possible.
Any help / advice will be much appreciated!