View Full Version : lost pumps
I have installed a new mp10 qd and upgraded the drivers on the remaing 3 to mp10 qd. the vortex controller sees them as mp40wwd. my touch only shows pumps 1 and 3 and the speed or % is wrong. is there a fix. Andre
Are you able to control the second pump from GCC without issues? Is this pump programmed the same way as the 1st and 3rd pump?
What FW version are you running on the ProfiLux Touch?
Are you able to control the second pump from GCC without issues? Is this pump programmed the same way as the 1st and 3rd pump?
What FW version are you running on the ProfiLux Touch?
Firmware 1.05 all 4 of my pumps are programmed the same way they are set up to do tidal swell mode and that is what they are doing but the touch says 1 is 80% and 3 is 40% all day long the other pumps do not even show on the touch.
I have now updated the touch and still only shows pump 1 at 80 and pump3 at 40 and I added one more pump to tank so now have 5 running and they are doing the Tidall swell mode as per ecotech and are controlled by the vortech controller. to solve the problem till there is a fix I do not display pumps on the touch
I think that once the vortech controller is fixed then the profilux will see the pumps and they will show on the Touch
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.