PDA

View Full Version : Dosing problems after firmware update to version 6.25



harmjan
03.03.2016, 12:13
Hi all,

Last Sunday I succesfully upgraded my Profilux 3 from firmware version 6.19 to firmware version 6.25. Furthermore I did normal maintenance and a 20% water exchange.
Monday evening I discovered a lack of oxygen to my discus fish. Cause unknown. I decided to do an extra water exchange and use an air pump to add extra oxygen in the water. Oxygen problem solved, cause still unkown.

This morning I heard a strange sound: my dosing pump (Dosing Pump version 1) was pumping to long. I checked the fluids (Easy Carbo, Easy Life Profito) and both bottles were almost empty, which I didn't expect. To cut a long story short: with firmware version 6.25 dosing (with the timer options / setting: manual dosing) goes wrong. I have scheduled 3 ml (with 60 ml/minute), and the pump doses for 30 seconds! 10 times too long/too much!

I downgraded the Profilux to firmware version 6.19. Dosing works fine again.

Has anyone the same experience? This is a very dangerous and costly problem. The fish were nearly poisoned, I hope they dont suffer permanent injury. And off course it consumes very much expensive fluids!

harmjan
27.03.2016, 12:40
I was wondering if anyone is experiencing the same problem... after more than 3 weeks I haven't received a reply yet.

Vinny
28.03.2016, 14:56
Hi,

We have not received any more reports of this exact problem. Although the gen 1 dosing pumps can be programmed using the "Timer" settings, we recommend you migrate all those settings to the "Dosing Pump" section.

harmjan
23.04.2016, 18:22
Hi,

I have migrated the dosing pumps from the Timers to the Dosing Pumps section.
I can confirm my Profilux and the dosing pumps are running smoothly with firmware 6.26 for two weeks now.
Thanks for your advice.