What's needed to connect DIY led?

[d2mini]

I'm looking at adding a DIY led strip to my setup using a dimmable solderless kit from RapidLED.
What would I need to hook this up to my Profilux so I can control them?

[PIWAWT]

If you use a Kit like this (http://www.rapidled.com/06-solderless-led-retrofit-kit-dimmable/), then you need a LFB-AP

[d2mini]

Thank you!
There seems to be very little information out there on this part and I don't see it on the GHL website.
I assume the wires from the LED drivers connect to this, and then this connects to the Profilux via a Cat5 cable? Which port?

[PIWAWT]

with a RJ12 Cable to 1-10V Port (L-Port)